Advanced Digital 2 Block Dry Block Heater with Heated Lid, 230V
|PART #||949503HL||Control Type||Digital||Block Capacity||2 block|
|Watts||400||Temperature Range||Ambient +5°C to 100°C||Temperature Stability at 37˚C||± 0.2°C|
|Uniformity Within the Block at 37˚C||± 0.2°C||Uniformity Across Similar Blocks at 37˚C||± 0.1°C||Heat-Up Time to 100˚C||50 min|
|Dimensions||15.4 x 8 x 7"
(39.1 x 20.3 x 17.8 cm)
|Operating Conditions||Units can be run in conditions from 18 to 33°c (64 to 91°F), 20% to 80% relative humidity, non-condensing||Applications||Isothermal incubation, enzyme reactions, immunoassays, nucleic acid denaturation and a wide variety of other laboratory procedures.|
|Certifications||CE Mark||Warranty||5 year industry leading limited warranty on parts and labor.||Unit Supplied With||Units include a 92" (234cm) detachable cord with Euro (type) plug.|
|Origin||Manufactured in the USA|
|Microprocessor Control||PID temperature control, with optional external RTD probe, affers a temperature stability as low as ±0.1°C. Samples are heated to temperature quickly and accurately. Temperature is adjusted in ±0.1°C increments.|
|LED Display||Touch pad controls with easy-to-read, independent LED displays for temperature, and time. Provides repeatable and accurate results every time and is easily visible across lab benches. Shows set-point and actual temperature. Timer will display elapsed time or, when programmed to user defined limit, will shut off unit when time reaches zero. Display will show last used settings, even after power has been turned off.|
|Audible Alarm||In timed mode, alarm will sound when time reaches zero and when unit reaches set-point temperature.|
|Temperature Calibration Mode||Allows user to calibrate unit to an external temperature device.|
|Caution Hot Indicator||Hot warning symbol light is illuminated when temperature is above 40°C.|
|Overshoot Protection||If the unit exceeds the set temperature by 10°C the unit will automatically stop heating.|
|CAUTION!||To avoid possible electrical hazard, do not fill well or block opening with water or other fluids. Unit is designed as a dry bath/incubator.|
For use in the United States, typical voltage is 120V. 120V units are supplied with standard 3-prong grounded plug.
For use outside the United States or for 230V applications, 230V units are supplied with a Euro type plug. If you require a different plug type, please specify the part number listed below in the comments when ordering. For plug types not displayed below, please contact Inside Sales at +1-800-352-7705. All plugs supplied are standard IEC 320 type connector.